Electrode Welding - GYS MULTIPEARL AUTO Manual De Instrucciones

Translation of the original instructions
• Hot Start adjustment

ELECTRODE WELDING

• The reverse polarity cable must be disconnected in MMA (stick welding) mode in order to connect the electrode holder and earth
clamp. Connect the electrode holder and earth clamp as indicated on the electrode packaging.
• Respect the basic rules of welding
• This device has 3 features specific to Inverter machines :
- Hot Start: Increases the current to assist the initial striking of the arc.
- Arc Force: A ponctual increase of current avoiding the electrode to be stuck in the welding pool.
- Anti-Sticking: Enables easy removal of the electrode from the metal.
TIPS :
Low Hot Start for thin metal sheet and high Hot Start for more difficult metal to weld (dirty metal or oxidised).
TIG PRO (EURO TORCH)
• Selecting TIG Pro mode (Euro torch)
• Welding current adjustment
• Downslope adjustment
• Post gas adjustment
TIG EASY (VALVE TORCH)
• Entering in TIG EASY mode (valve
torch)
MULTIPEARL AUTO
Keep pressing button 3 and at the same
time turn the upper knob to adjust the
Hot Start.
Adjustable from 0 to 100%
Keep button 2 pushed and at the same
time turn the upper knob until «TIG Pro»
is displayed.
Use the upper knob.
Use the lower knob.
Keep button 3 pushed and at the same
time use the upper knob to adjust the
Post Gas.
Keep button 2 pushed and at the same
time turn the upper knob until "TIG
EASY" is displayed.
+
+
+
+
EN
25