Keep-Warm Function - Beem 02938 Manual De Instrucciones

25
Aroma Plus Function
The brewing time can be extended with the aroma plus function. The extended brewing time
will give your coffee a more intense aroma.
1. First select the number of cups you want and the coffee strength (see previous sections).
We recommend that you only use the fl avour function for 2 or 4 cups. This is because
the brewing time for 6, 8 or 10 cups is long by default. An even longer brewing time
could make the coffee too bitter.
2. Press the button (20) for at least 2 seconds until the display (7) shows
Please Note! The aroma plus function switches off automatically after each brewing
process.

Keep-Warm Function

The device has an automatic keep-warm function. The hotplate remains switched on for ap-
prox. 40 minutes after each brewing process.
To end the keep-warm function prematurely, press the
If you are using the device with a thermal jug, switch off the keep-warm function by
pressing the button
the display (7). The hotplate is not switched on after the brewing process. The device
switches directly to stand-by mode.
Please Note! As the design of the device means that the hot water lines run under the
surface on which it is placed, the thermal jug gets hot during the brewing process. This is
normal and does not represent a defect.
The keep-warm function can be switched on again by once more pressing the
button for approx. 5 seconds. The
Drip Stop
The device has a drip stop which prevents water from dripping out of the fi lter when the jug
has been removed from the device.
When the device is in operation, the fi lter compartment (5) must be closed and a jug with a lid
placed on it must be placed beneath the fi lter compartment. The lid of the jug pushes the drip
stop upwards and the coffee can fl ow from the fi lter through the lid into the jug.
During the brewing process, the jug must not be removed from the device for longer
than 30 seconds as otherwise the fi lter could overfl ow.
(26) for approx. 5 seconds. The
symbol appears on the display.
(13).
button (19).
symbol goes out on
EN