Descargar Imprimir esta página

Gymrex GR-MG74 Manual De Instrucciones página 58

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 185
7. Press and hold the RESET button for 2 seconds to reset all the settings made.
8. Press TOTAL RESET to reset and restart the display control panel.
9. Manually set the resistance level of the flywheel assembly by operating the
resistance setting dial – the arrow tip on the dial is to be set at the desired level
(one of the eight available).
10. Operate the seat setting clamp to adjust the seat:
• Undo the setting clamp knob.
• Pull up the seat post and set in position by engaging the setting clamp knob into
the respective detent in the tube.
• Tighten the setting clamp to secure the seat in position.
11. Place your feet firmly on the pedals and secure them in the pedal straps. Start
your training and adjust the settings as desired.
12. After 4 minutes of inactivity, the display will revert to standby mode.
CAUTION! If the product will not be used for a long time, remove the batteries and
fold down the product.
3.4.3. Model GR-MG78:
1. Install the batteries in the battery holder in the back of the control panel – mind
the polarity. The display will read "0" for every setting.
2. After a short while, the display switches to the setting input mode. Press the
MODE button. The first setting to input is TIME.
3. Use the SET button to input the setting value: each press increases the value by
one increment – one minute for time and 10 m for distance. The values cannot be
reduced until the display rolls over. If you make a wrong input, re-enter the setting
by operating the MODE button.
4. The next settings to input are distance (DIST) and calories burnt (CAL).
Parameter designation
Time (minutes)
Distance (kilometres)
Calories
5. Press the RESET button during your training to reset the settings made to zero.
5. Manually set the resistance level of the flywheel assembly by operating the
resistance setting dial – the arrow tip on the dial is to be set at the desired level
(one of the eight available).
6. Operate the seat setting clamps to adjust the seat.
Setting range
0:00 to 99:00
0.00 to 999.0
0 to 9990

Publicidad

loading

Este manual también es adecuado para:

Gr-mg75Gr-mg78Gr-mg79