ARGENTO Alpha Manual De Instrucciones página 19

Removing the battery:
Insert the key supplied in the lock on the frame and,
after turning the key counterclockwise to the unlocking
position, proceed to remove the battery from its fixing
seat in the frame.
Battery charging
Before using the electrically power assisted cycle for the first time, the battery must be fully charged using the battery charger
supplied.
The average time to fully charge the battery, which varies according to the residual charge level of the battery, can be
estimated as shown in the sheet below.
We recommend charging the battery with the specific battery charger after each use of the electrically power assisted
cycle.
CAUTION
Only use the battery charger provided or an approved model with the same technical specifications, taking care to observe
the same methods and precautions of use indicated on the charged or in the manual.
EPAC
Alpha
Omega
Make sure that the electrically power assisted cycle is switched off and the battery is switched off/disabled (if required by the
model of battery supplied with the bike).
Make sure that the battery charger, its jack and the charging port of the battery are dry.
Connect the battery charger jack to the battery charging port and then, the mains power socket (230V/50Hz).
There is a red indicator light when the battery is charging. When the indicator light turns green, it signals that the battery
charging cycle has been completed.
Disconnect the battery charger jack from the battery charging port and then, the mains power socket.
Battery charger INPUT
AC 100V-240V 1.8A (Max)
AC 100V-240V 1.8A (Max)
Inserting the battery:
Insert the battery into its seat integrated into the frame
of the bicycle until it locks.
Check that the battery is correctly installed and secured
by trying to pull it out and/or making sure that it is
securely fastened to the frame and does not move.
Battery charger OUTPUT
DC 42V 2.0A (Max)
DC 42V 2.0A (Max)
18
Recharge life
4-6 h
4-6 h