OPERATION OF THE REMOTE CONTROL
1
Switching ON
Take the radio command code no. PTVTEL:
•
On channel «1», press the button as shown in fig. 9
•
Red LED lights up Fig.10
MIN
Fig.10
2
Setting power.
Take the radio remote control unit cod. PTVTEL:
•
On channel «1», press the button as shown in fig. 11
•
Yellow LED lights up Fig.12 medium power
•
On channel «1», press the button as shown in fig. 13
•
Green LED lights up Fig.14 maximum power
Fig.11
When switched on for the first time with the power supply switched on (230Vac), pressing the ON button
will set the controller to idle (red LED).
During the following starts, pressing the ON button will set the controller to the last power selection set
(status MEMORY).
MED - MAX
Fig. 12, 14
( Red, Yellow, Green ) according to the
16
Fig.9
Fig.13
The LED changes colour
set power level.
CHANNEL 1....12