Assembly And Operation - Worx WX647 Manual Original

The machine is intended for dry sanding of wood, plastic,
filler and coated surfaces.The sander is not to be used for
plastering.

ASSEMBLY AND OPERATION

ACTION
ASSEMBLY
* Fitting the Sanding Paper
Using The Dust Adapter
Attaching the Dust Box
CAUTION: To prevent the
possibility of sanding dust or
12 foreign body being thrown into your face
or eyes, never attempt to use your sander
without the dust box properly installed.
Emptying the Dust Box
-For more efficient operation, empty
dusts box every 5-10mins.
OPERATION
On/Off Switch
Flush Sanding Facility
* Installing The Finger Pad
* Removing The Finger Pad
* Attach Sanding Sheets And Pads
Sanding With Finger Pad
*
FIGURE
injury.
WORK HINTS FOR YOUR PALM SANDER
See Fig. A
If your power tool becomes too hot, run no load for 2-3 minutes
to cool the motor.
See Fig. B1, B2
Always ensure the work-piece is firmly held or clamped to
prevent movement.
Any movement of the material may affect the quality of the
sanding finish.
See Fig. C
Start your sander before sanding and turn off only after stopping
sanding. For best results sand wood in the direction of the grit.
Do not start sanding without sandpaper fitted.
Do not allow the sandpaper to wear away, it will damage the
base-plate. The guarantee does not cover base-plate wear and
tear.
See Fig. D1, D2, D3
Use coarse grit paper to sand rough surfaces, medium grit for
smooth surfaces and fine grit for the final surfaces. If necessary,
first make a test on scrap material.
Use only good quality sandpaper.
The sanding efficiency is controlled by the sandpaper not the
See Fig. E
amount of force you apply to the tool. Excessiveforce will reduce
the sanding efficiency and cause motor overload. Replacing
See Fig. F
the sanding paper regularly will maintain optimum sanding
efficiency.
See Fig. G1, G2
MAINTENANCE
See Fig. H1, H2
WARNING: Failure to unplug the sander could result in
accidental starting causing possible serious personal
See Fig. I
See Fig. J