Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
‰ Insert the escutcheon into the rough opening with the double ribs of the leak shield facing up.
‰ If the leak shield contacts the elbow: enlarge the hole in the back of the leak shield to 1-1/4" (32 mm).
‰ Thread the adapter onto the nipple using the provided 11 mm bit, 11 mm or 7/16" socket, extension and
socket wrench. Use masking tape to hold the bit in place to prevent it from falling off and causing damage.
IMPORTANT! The escutcheon should sit loosely at this point. If it is tight against the wall, use a longer pipe
nipple.
‰ Align the groove in the waterway with the double ribs on the leak shield.
‰ Press the waterway into place over the adapter. Secure the waterway to the adapter with the screw
provided.
‰ Verify that the escutcheon does not turn or shift.
IMPORTANT! If the escutcheon is still loose after this step, use a shorter pipe nipple.
1506293-2-A
7 of 23
5. INSTALL THE WATERWAY
Leak Shield
Escutcheon
Socket Wrench
With Bit
Double Ribs
Adapter
Extension
Groove
Questions? Problems? For additional assistance, please contact KALLISTA's Customer
Service Department at 1-888-4-KALLISTA (1-888-452-5547) or kallista.com.
Bodyspray
Waterway
Screw
Publicidad
