Publicidad
Idiomas disponibles
Idiomas disponibles
2.5 Personal Protective Equipment
(PPE)
When working with rotating parts, it is not permitted to
wear gloves.
Recommendation: Freely rotating u-GUARD pro-
tected fastening tools are available from APEX.
Wear close-fitting clothing.
Wear safety shoes.
If necessary, wear a hairnet.
Wear protective goggles, if there is a risk of flying
debris or parts being elected.
2.6 Warnings and Notes
Warning notes are identified by a signal word and picto-
gram:
•
Signal word: describes the severity and the probability
of the impending danger.
•
Pictogram: describes the type of danger.
Danger
Symbol combined with the word Danger in-
dicates a hazard with a high level of risk
which, if not avoided, will result in death or
serious injury.
Warning
Symbol combined with the word Warning
indicates a hazard with a medium level of
risk which, if not avoided, could result in
death or serious injury.
Caution
Symbol combined with the word Caution in-
dicates a hazard with a low level of risk
which, if not avoided, could result in minor or
moderate injuries or environmental dam-
age.
Note
An symbol combined with the word Note in-
dicates a potentially harmful situation which,
if not avoided, could result in damage to
property or the environment.
General notes
includes application tips and useful infor-
mation, but no hazard warnings.
2.7 Symbols on the Product
Be sure to understand the meaning of each symbol below
prior to installation, operation or maintenance service.
Apex Tool Group
Electrical voltage
CE compliant
The product corresponds to the prescribed
technical requirements in Europe.
Read all instructions.
2.8 Standards
2.8.1 FCC and IC compliance
This product complies with Part 15 of the FCC Rules. Any
changes or modifications not expressly approved by the
manufacturer could void the user's authority to operate this
product. Operation is subject to the following two condi-
tions:
•
this product may not cause harmful interference, and
•
this product must accept any interference received,
including interference that may cause undesired oper-
ation.
FCC Responsible party
Name: William Cain
Position: Director, R&D
Address: 670 Industrial Drive
Lexington, SC 29072
United States
Phone: +1 803 951 7558
Email: William.Cain@ClecoTools.com
This product has been tested and found to comply with the
limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide rea-
sonable protection against harmful interference when the
product is operated in a commercial environment. This pro-
duct generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to
radio communications.
Operation of this product in a residential area is likely to
cause harmful interference in which case the user will be
required to correct the interference at his own expense.
2.9 System Relevant Safety
Instructions
Follow national, state and local safety and connection stan-
dards during installation. The standards take precedence
over the information in this section.
P2552HW | 2021-04
1
EN
7
Publicidad
