Descargar Imprimir esta página

Cleco mPro300GCD-STO Manual Del Usuario página 9

Ocultar thumbs Ver también para mPro300GCD-STO:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 36
During remote-start operation (multiple tool setup) an inter-
ruption of TSNet bus leads to a delayed stop of the spindle/
tool. This delay is 2 seconds.
Maintenance
 The controller is generally maintenance-free.
 Consider local regulations for maintenance and servic-
ing for all operating phases of the tightening system.
Cleaning
 Only clean the exterior of the tool using a dry or slightly
damp cloth.
 Do not immerse the controller or tools in any liquids.
 Do not use a high pressure or abrasive cleaner.
 Disinfection of surfaces with alcohol-based disinfectant
is permitted.
Repair
Repairs to the equipment are not permitted.
 Send the controller to a Authorized
Cleco Production Tools Sales & Service Centers.
Disposal
Components of the tightening system may present poten-
tial risks the environment. The tightening system contains
components that can be recycled, as well as components
that have specific disposal requirements.
 Follow local applicable regulations.
 First separate, then dispose of components.
 Collect auxiliary materials (oils, greases) and dispose
properly.
 Separate the components of the packaging and dis-
pose of them according to local regulations.
 Return defective equipment to an approved collection
point or return it to the Sales & Service Centers.
Observe local regulations for disposal of
electronics and batteries. (In Germany,
the Electrical and Electronic Equipment
Act (ElektroG) and the Battery Act
(BattG)):
 Used up batteries must be disposed
of properly. Return depleted or defec-
tive batteries to an approved collec-
tion facility or to Sales & Service
Centers for recycling.
Apex Tool Group
P2552HW | 2021-04
1
EN
9

Publicidad

loading