Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Once the hose connection is complete, check for leaks at the connection points
by fully opening the taps. If you find any leaks, close the tap and remove the nut.
Tighten the nut carefully after checking the seal. To prevent water leaks and resulting
damage, keep the taps closed when not using the product.
Exhaust duct connection
•
Attach the end of the drain hose directly to the drain, toilet or bathtub.
WARNING!
•
Your home will be flooded if the drain hose comes out of its housing
while draining. In addition, there is a risk of burns due to high washing
temperatures I To prevent such situations and to ensure that the machine
operates the water inlets and outlets without problems, securely attach the
drain hose.
•
Connect the drain hose at a minimum height of 40 cm and a maximum height of 100
cm.
•
If the drain hose is lifted after it has been laid at or near ground level (less than 40 cm
above the floor), water drainage becomes more difficult and the laundry may become
quite wet. For this reason, the heights described in the diagram must be observed.
•
To prevent the waste water from re-entering the machine and to ensure easy drainage,
avoid dipping the end of the hose into the waste water or inserting it into the drain
pipe by more than 15 cm. If the hose is too long, cut off the excess.
•
The end of the pipe must not be bent, squashed or kinked between piping and the
machine.
•
If the hose length is very short, you can add an original extension hose. The length of
the hose may not exceed 3.2 m. To prevent malfunctioning caused by possible water
57
Publicidad
