Ingeteam NEO Manual De Instalación página 22

Ingeteam
3. Put the STAND element next to the cable output on the ground, and pass the power supply cables and
the auxiliary wiring (to connect other devices) through the hollow interior from the bottom until they can
be pulled out via the corresponding grommet.
4. Fix the STAND element to the ground.
5. Install the charger on the STAND element. Follow points 7 to 11 of the charger assembly instructions.
CAUTION
The fasteners to be used in this case must be those provided with the STAND element and not those provided
with the charger.
CAUTION
Due to the fact that the power supply to the charger is not via the side of the charger in this case, that access
must be covered with the blind grommet provided with the charger.
22
Auxiliary wiring
Electrical wiring
ABV2013IQM01_ - Installation manual
Installation