Operation Parameter - Sime SHP M PRO Manual De Funcionamiento

6.7 OPERATION PARAMETER

The OPERATION PARAMETER function is for installer or service engineer
to review the operation parameter.
You can check the water temperature, water flow, pressure and other
parameters by using "OPERATION PARAMETER".
1. POWER CONSUM is for reference only, not used to judge the
actual power consumption. Keep pressing ''▼" and ''►''at the
same time for 8 seconds, then POWER CONSUM can be reset
to zero.
2. HEAT PUMP CAPACITY is for reference only, not used to
judge the actual capacity of the unit.
3. If some parameter is not activated in the system, the
parameter will be displayed "--".
4. The accuracy of sensor is ±1℃.
5. The flow rate is calculated according to the pump running
parameters, the deviation is different at different flow rates,
the deviation is about 15%.
6. The flow rate is displayed "0" when the voltage is less than
198V.
INFORMATION
i
54