Operation; Bead Breaking; Wheel Clamping - Nussbaum TC 110 Manual De Instrucciones

WARNING:
Unreadable and missing warning labels must be replaced immediately.
Do not use the tyre changer if one or more labels are missing.
Do not add any object that could prevent the operator from seeing the labels.
Use the code in this table to order labels you need.
WARNING!
During all operations, keep hands and other parts of the body as far as possible from moving parts of the machine.
Necklaces, bracelets and too large clothes, can be dangerous for the operator.
10.1 BEAD BREAKER
WARNING!
Bead breaking must be done with the utmost care and attention.
When the bead breaker pedal is operated the bead breaker arm moves quickly and powerfully.
Anything within its range of action can be in danger of being crushed.
WARNING!
Remember to remove all weights from both sides of the rim before operating the machine.
1) Deflate the tyre completely and remove the valve core.
2) Close the table top gripper slides completely.
WARNING!
Bead breaking with the table top slide grippers open can crush the operator's hands.
During bead breaking NEVER touch the walls of the tyre with your hands.
3) Open the bead loosener by hand by pushing it towards the outside.
Place the wheel up against the rubber wheel support (11, Fig. H). Bring the blade
(12, Fig. H) against the bead about 1 cm from the edge of the rim (See Fig. M).
WARNING! Position the blade as to operate the side of the tyre and not of the rim.
4) Push the blade (12, Fig. H) into the tyre by depressing pedal (3, Fig. H).
Repeat this process at different points around the tyre and on both sides until the
beads are completely loosened.
10.2 WHEEL CLAMPLING
1) Check to make sure there are no weights on the rim.
2) Apply tyre lubricant on the bead.
3) The rim can be clamped on the table top from the inside or the outside.
TC 110 - Liga C 200

10. OPERATION

24
ENGLISH • Instructions manual
M