Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
B
Using the appliance
8. Remove the upper left hinge cover and upper left hinge from the accessory bag.
Place the refrigerated door body on the middle hinge and install the upper left hinge.
Connect the refrigerator top signal line
2
signal line
to the signal line
3
. Finally, replace the hinge decorative cover to the right
side of the box body.
NOTE:
When replacing the hinge decorative cover to the right side
of the box body, the two inserts on the hinge decorative
cover (as shown in the figure) shall be cut off.
4
upper hinge
The picture above is only for reference. The actual configuration will depend on the physical
product or statement by the distributor.
14
4
1
to the door body signal line
, and connect the
upper hinge cover
decorative cover
inserts
3
2
1
EN
B
Using the appliance
Changing the light
• Any replacement or maintenance of the LED lamps is intended to be made by the
manufacturer,its service agent or similar qualified person.
Light source in this product is replaceable only by qualified engineers.
1. Please take out the plug before removal.
2. Remove the lampshade with a screwdriver.
3. Take down the lamp panel.
4. Remove the connection terminal.
Starting
• After transportation, please let the product stay for more than 2 hours before turning on
the power, otherwise it will lead to a decrease in cooling capacity or a damage to the product.
• Before putting any fresh or frozen foods, the refrigerator shall have run for 2-3 hours, or
for above 4 hours in summer when the ambient temperature is high.
• Please pull out the plug in case of power failure or cleaning. Do not connect the freezer to
power supply within five minutes to prevent damages to the compressor due to successive
starts.
15
EN
Publicidad
Tabla de contenido
