cecotec BOLERO COOLMARKET 4D 454 INOX Manual De Instrucciones página 81

- Clean the interior of the refrigerator with a weak solution of baking soda and then rinse
it with warm water using a wrung-out cloth or sponge. Dry it completely before placing
the shelves and the crisper drawers back. Dry all the surfaces and the detachable parts
thoroughly before placing them back in place.
Defrost
Even if the refrigerator has an automatic defrost function, there could be a layer of frost in the
interior of the freezer compartment if the door has been frequently open or if it has been open
for a long period of time. If the frost is too thick, follow these steps:
1. Remove the food and the crisper drawers, unplug the refrigerator from the mains and
leave the doors open. Ventilate the room well to speed up the defrosting process.
2. When it has been completely defrosted, clean the refrigerator following the process
described.
Warning
- Do not use sharp objects to remove frost.
- You should only plug and turn on the refrigerator when the interior is completely dry.
Cleaning the gasket of the doors
Try to keep the gasket of the doors clean. Sticky food and drinks can cause the gaskets to stick
to the structure of the refrigerator and break when the door is opened. Wash the gasket with a
soft detergent and warm water. Rinse it and dry it thoroughly after cleaning it.
Warning
You must only turn the refrigerator on after the gaskets of the door are completely dry.
Substitution of the LED light
Warning
The LED light can only be substituted by authorised personnel. If the LED light is damaged,
contact the official Customer Service of Cecotec for assistance.
To replace the LED light, follow these steps:
1. Unplug the refrigerator.
2. Remove the light cover by pressing it upwards and outwards.
3. Hold the LED light cover with a hand and pull with the other while you press the connector.
4. Substitute the LED light and place it correctly in place.
BOLERO COOLMARKET 4D 454 / INOX / DARK
ENGLISH
81