Publicidad
Idiomas disponibles
Idiomas disponibles
Connecting with Mi Home/
Xiaomi Home app
This product works with Mi Home/Xiaomi
Home app*. Control your device with Mi
Home/Xiaomi Home app.
Scan the QR code to download and
install the app. You will be directed
to the connection setup page if the
app is installed already. Or search "Mi
Home/Xiaomi Home" in the app store to
download and install it.
Open Mi Home/Xiaomi Home app, tap
"+" on the upper right, and then follow
prompts to add your device.
*The app is referred to as Xiaomi Home
app in Europe (except for Russia). The
name of the app displayed on your
device should be taken as the default.
Note: The version of the app might have been
updated, please follow the instructions based on
the current app version.
Resetting Wi-Fi
Long press
and
simultaneously for 3 seconds. After hearing the voice prompt
"Enter the Mi Home app network configuration mode", the power indicator and the
recharging indicator will blink green, and the robot will wait to connect to the Mi
Home app.
Tips: Only 2.4 GHz Wi-Fi is supported.
Notes about roller brushes
The robot can be equipped with a mixed bristle roller brush or a pure soft bristle roller
brush as required. The mixed bristle roller brush is installed by default.
Mixed bristle roller brush: a versatile, general-purpose brush for matte floors, plastic
floors, and stubborn stains that are difficult to remove
Pure soft bristle roller brush: a fine soft bristle roller brush for high-gloss floors, wooden
floors, and daily cleaning and maintenance.
Air drying for the roller brush
Air drying in the charging base: The charging base will automatically air dry the roller
brush when it recognizes that a roller brush has been installed. If the roller brush is
taken out during air drying and then replaced, the robot will start timing the air drying
again.
Air drying in the robot: The robot will automatically air dry the roller brush after
completing self-cleaning (in dry sweeping mode, the robot does not perform air
drying after completing self-cleaning). If the roller brush, water tank, or water tank
cover is taken out during air drying, the robot will pause air drying. Once the removed
component is installed back, the robot will continue air drying.
Tips:
Both the robot and the charging base provide air drying for the roller brush.
The charging base takes approximately 12 hours to air dry the roller brush, and the robot takes
approximately 6 hours to air dry the roller brush.
If the power supply to the charging base is disconnected during air drying, air drying stops.
When the robot is in the air drying state, long press
When the robot is in the charging state, long press
mode of charging only. And press
12
for 3 seconds to stop the air drying.
and
for 30 seconds to enter the deep sleep
to exit this mode.
Publicidad
