Care Of The Spa Cabinet; Care Of The Spa Cover; Cover Lifter System - HotSpring HOT SPOT Serie Manual Del Propietário

minerals. (WATKINS WELLNESS recommends FRESHWATER
Stain & Scale Defense.)
3. Keep all cleaners out of the reach of children and use care when
applying.

CARE OF THE SPA CABINET

The simulated wood cabinet consists of a rigid polymer that combines
the durability of plastic, with the beauty of wood.
Cleaning of simulated wood consists of simply spraying the cabinet with
a mild soap and water solution to remove any stains and residue.

CARE OF THE SPA COVER

WARNING: The cover is a manual safety cover that meets or
exceeds all prevailing requirements of ASTM 1346-91 for spa safety
covers when installed and used correctly as of the date of manufacture.
Non-secured, or improperly secured covers are a hazard.
Open the cover to its fully open position before use.
VINYL COVER
The vinyl spa cover is an attractive, durable foam insulation product.
Monthly cleaning and conditioning are recommended to maintain its
beauty.
To clean and condition the vinyl cover:
1. Remove the cover from the spa and gently lean it against a wall or
fence.
2. With a garden hose, spray the cover to loosen and rinse away dirt or
debris.
3. Using a large sponge and/or a soft bristle brush, and using a very mild
soap solution (one teaspoon dish washing liquid with two gallons of
water), or baking soda (sodium bicarbonate), scrub the vinyl top in a
circular motion. Do not let the vinyl dry with a soap film on it before it
can be rinsed clean.
4. Scrub the cover's perimeter and side flaps. Rinse clean with water.
5. Rinse off the underside of the cover with water only (use no soap),
and wipe it clean with a dry rag.
6. To condition the cover after cleaning, apply a thin film of HOT
SPRING Cover Shield to the vinyl surface and buff to a high luster.
IMPORTANT: To remove tree sap, use cigarette lighter fluid (not charcoal
lighter fluid). Use sparingly, and rinse with a saddle soap solution
immediately afterwards, then wipe dry.
DO:
• Remove snow buildup to avoid breakage of the foam core from the
additional weight of the snow.
• Lock cover lock straps to secure the cover when the spa is not in use.
DON'T:
• Drag or lift the spa cover using either the flaps, or the cover lock straps.
• Walk, stand, or sit on the cover.
• Place any metal or heat transferring object on the cover or place any
type of plastic tarp or drop cloth over the cover as this may result in a
melted foam core, which would not be covered under the warranty.
• Use any lifting mechanisms, chemicals, or cleaners except those
recommended by WATKINS WELLNESS, or its Authorized Sales and
Service Dealer.
English Spanish

COVER LIFTER SYSTEM

Clearance required behind cover when open:
CoverCradle
HOW TO OPEN THE VINYL COVER
IMPORTANT: Never attempt to open or remove the vinyl cover by
grasping or pulling on the skirting or cover lock straps. The skirting will
tear, and torn skirting is not covered under the terms of the warranty.
Check for ice build-up around the gas springs and pivot points of the
retractable cover system. Ice buildup may damage system components.
WARNING: The vinyl cover and retractable cover system are not
recommended for use in wind conditions reaching above 25 mph (40 kmh).
IMPORTANT: If your spa is located in an area susceptible to high winds,
additional cover lock straps may be installed to minimize wind damage
to the cover.
1. With the cover lock straps unfastened, place one hand under the
cover skirting, between the spa and cover, to break the cover's
vacuum seal. Then, fold the front half of the cover over onto the back
half.
2. If no rear access is available, stand to the side of the spa directly
adjacent to the hinge area of the folded cover.
a. For the COVERCRADLE retractable cover systems: Using
both hands, cup one hand under the lower half of the cover
(just above the water) and place the other along the side of
the cover, just above the skirt. Gently push (do not lift) with
both hands towards the opposite rear corner of the cover
(diagonally). As the cover opens, the gas springs will allow the
cover to come to a gentle stop.
b. For the UPRITE retractable cover system: Simply lift the
cover at its center hinge, allowing it to move to the back of the
spa and to rest gently there.
IMPORTANT: When opening a cover with a retractable cover system,
only use one of these three specific methods. Do not attempt to open the
cover in any other way. Damage caused by improper opening or closing
of the cover is not covered under the terms of the limited warranty.
HOW TO CLOSE THE COVER
1. Standing along side the cover, place one hand on the upper corner
of the cover and gently push forward in the direction of the spa. The
cover will rotate forward to cover half of the spa.
IMPORTANT: For the UPRITE retractable cover system, disengage
the locking mechanism(s) before pushing the cover forward.
2. Unfold the cover by lifting the handle located on the top (front) half of
the cover. Allow the unfolded half to fall down onto the spa. The air
pressure created by the cover falling will keep the vinyl skirting from
being trapped between the cover and the spa shell.
Page 23
French
® & CoverCradle II
24"
Spa Care and Maintenance
Spa Care and Maintenance
UpRite
®
7"