Mounting The Tv On A Wall; Swivel Stand; Securing The Tv To A Wall To Prevent Falling - Insignia NS-PDP42-09 Guia Del Usuario

2 Install the cable management clip to route the
cables. If your TV has cable holders, install
them to bundle the cables.
Cable management
Cable holder
clip
To remove the cable management clip:
Warning
Do not grip the cable management clip when
moving the TV because it may break or separate
from the TV, causing the TV to fall. This could
result in possible injury or damage to your TV.
• Hold the cable management clip with both
hands and pull it upward.

Mounting the TV on a wall

This TV accepts VESA FDMI-compliant mounts
using the four screw holes on the back of the TV.
These mounts are sold by third parties and not
available from Insignia. Refer to the instructions
included with the mount for more information.
Note
The screw length required depends on the wall
mount used. Refer to the instructions included
with the wall mount.
To install a wall mount bracket:
1 Remove the stand by performing the stand
installation instructions in reverse.
2 Install the included protection cover over the
hole for the stand.
10
Cable
Cable
holders
management
clip

Swivel stand

Securing the TV to a wall to prevent falling

www.insignia-products.com
Insignia NS-PDP42/50-09 Plasma TVs
3 Mount the wall bracket to the TV, using the
screw holes indicated in the illustration.
15.75 in (400 mm)
After installing the TV, you can adjust the TV
manually 20° to the left or right to suit your
viewing position.
We recommend that you set up the TV close to a
wall so it cannot fall over if pushed backwards.
We also recommend that the TV be attached to
a wall so it cannot be pulled over forward,
potentially causing injury or damaging the TV.
You may need to purchase the necessary
hardware to do this.
Caution
Make sure that children do not climb on or hang
from the TV.
To secure your TV to the wall:
1 Insert eye-bolts (or TV brackets and bolts) in
the top mounting holes on the back of your
TV. If your TV has screws in the eye-bolt
holes, remove them before inserting the
eye-bolts.
15.75 in
(400 mm)