cecotec bolero SQUAD V 3000 Manual De Instrucciones página 52

ENGLISH
be used as worktop material unless impregnated) to avoid electric shock or deformation
caused by heat radiation from the hob.
Note
The safety distance between the sides of the hob and the interior surfaces of the worktop
must be at least 3 mm.
Fig. 3
L (mm) W (mm)
590 520
In any case, make sure the hob is well ventilated and the air inlet and outlet are not blocked.
Check figure 4.
Note
The safety distance between the hob and a cabinet over the hob must be at least 760 mm. Fig.
5
Fig. 4
A (mm) B (mm)
760 Min. 50
Proper ventilation
Fig. 6
To avoid accidental contact with the bottom of the hob while it is hot, or receiving an unexpected
electric shock during use, it is necessary to place a wooden insert, fixed with screws, at a
minimum distance of 50 mm from the bottom of the hob. Follow the indications on figure 6.
Warning
There are ventilation gaps around the exterior of the hob. You must ensure these gaps are
-
not blocked by the worktop when placing the hob.
Please note that the glue that binds the plastic or wooden material to the furniture must
-
withstand a temperature of more than 150ºC to prevent the coating from peeling off.
The rear wall and the adjacent and surrounding surfaces must be able to withstand a
-
temperature of 90ºC.
52
H (mm) D (mm)
55 51
C (mm) D
Min. 20 Air inlet
A (mm) B (mm)
560 490
E
Air outlet 5 mm
X (mm) F (mm)
Min. 50 Min. 3