cecotec bolero SQUAD V 3000 Manual De Instrucciones página 53

Fixing brackets
You must place the unit on a stable and smooth surface (you can use the packaging). Do
-
not apply force to the buttons protruding from the hob.
Set the bracket position to adapt to the thickness of the worktop. Fig. 7
-
Secure the hob to the worktop by screwing the four brackets located on the interior part of
-
the hob (Fig. 8) after placing it on the worktop.
Fig. 7
1. Ceramic hob
2. Bracket
3. Worktop
Fig. 8
A: Screw
B: Bracket
C: Screw hole
D: Base of the ceramic hob
Warnings
Brackets should not, under any circumstance, touch the interior surfaces of the worktop
-
after installation. Fig. 7
It is recommended that qualified personnel or technicians install the hob. You should not
-
install it on your own.
You should not install the hob near cooling devices, dishwashers and dryers.
-
The hob must be installed in a manner that ensures the best heat radiation to obtain the
-
best results.
The wall and the area over the work surface must withstand the heat.
-
To avoid any damage, the bonding layer and the adhesive must be heat resistant.
-
You should not use steam cleaners.
-
Connection to the mains
Fig. 9
The power supply must be connected in accordance with the relevant regulations, or with a
single-pole residual current circuit breaker. The connection method is shown in Fig. 9
If the cable is damaged, it must be replaced by the manufacturer, the supplier or similarly
-
qualified personnel in order to avoid a hazard.
If the appliance is connected directly to the mains, a single-pole residual current circuit
-
breaker with a minimum contact separation of 3 mm must be installed.
The person in charge of the installation must ensure that a correct electrical connection
-
has been made and that it complies with safety regulations.
ENGLISH
BOLERO SQUAD V 3000
53