Publicidad
Idiomas disponibles
Idiomas disponibles
Translation of the Original Operating Instructions
Prior to each pressing of the "ON / Neustart" button, please make sure that
switching off was not the result of some other cause which must be eliminated
prior to each new start.
To stop the pump permanently, press the "Stop" button. If the pump was out of
operation for some extended period of time, the steps described above have to
be repeated for a renewed putting into operation. The electrical pumps of the
T.I.P. HWA series are equipped with an integrated thermal motor protection fea-
ture. In the case of overload, the motor will switch off independently and on again
after cooling down. For possible causes and their elimination, please refer to the
"Maintenance and troubleshooting" section.
8. Functioning of the electronic pump control system
8.1.
General information
The electronic pump control feature acts as a function of the pressure and the
water flow rate. On the one side, it will cause the automatic cutting-in or cutting-
out of the pump when the water tap or any other consumer component is opened
or closed. On the other side, the electronic pump control will trigger the automatic
9
26
Publicidad
