Craftsman CMXGZBF450568 Manual De Instructiones página 6

ENglISh
Step 5: (figure 5)
1. Align the two mount assembly brackets (6) over the
holes in both sides of the frame as shown.
2. Attach each mount assembly bracket (6) using two hex
bolts (J).
3. Secure each bolt with a NYLOC hex nut (F) and tighten.
Fig. 5
6
J
Step 6: (figure 6)
1. Lay the bed assembly (7) on a flat surface to assemble.
2. Attach the two bag mount brackets (8) to the bed
assembly (7) using two hex bolts (K) as shown.
3. Secure each bolt with a NYLOC hex nut (F) and tighten.
4. Insert two hex bolts (K) through the opposite side of the
bed assembly as shown.
5. Secure each bolt with a NYLOC hex nut (F) and tighten.
Fig. 6
7
F
4
F
8
F
K
AttACH tOOL rACK tO trACtOr OPtiOnS–
CrAftSmAn/HUSqvArnA/JOHn Deere
LAWn trACtOrS
The tool rack can be attached to the tractor in a couple ways.
1. Attach the tool rack directly to the rollover protection
structure (ROPS) on the tractor. (See "APPENDIX A" on
page 7 for instructions.)
2. Attach the tool rack to a mount assembly attached to
the back of the tractor. This type of installation varies
depending on the manufacturer of the tractor:
For Craftsman tractors, proceed to "Attach Mount
-
Assembly Option 1 - Craftsman" on page 4.
For John Deere 100 Series tractors, proceed to
-
"Attach Mount Assembly Option 2 - John Deere 100
Series" on page 5.
For husqvarna tractors, proceed to "Attach Mount
-
Assembly Option 3 - Husqvarna" on page 5.
Attach mount Assembly Option 1 -
Craftsman
Step 1: (figure 7)
1. Attach the mount assembly (9) directly to the back of
the Craftsman tractor using two hex bolts (J) as shown.
2. Secure each bolt with a washer (L) and NYLOC hex
nut (F) and tighten.
3. Proceed to "Attach Tool Rack to Mount Assembly" on
page 6.
Fig. 7
9
J
L
F