Publicidad
Idiomas disponibles
Idiomas disponibles
Attach mount Assembly Option 2 -
John Deere 100 Series
Step 1: (figure 8)
1. Attach two backing plates (11) to the back of the tractor
using hex bolts (N) inserted into the outside slots from
behind the tractor frame and through each backing
plate as shown.
Fig. 8
Step 2: (figure 9)
1. Place the mount assembly (9) onto the bolts as shown.
2. Secure with a washer (L) and NYLOC hex nut (F) on each
bolt and tighten.
3. Proceed to "Attach Tool Rack to Mount Assembly" on
page 6.
Fig. 9
9
11
N
L
F
L
Attach mount Assembly Option 3 -
Husqvarna
Step 1: (figure 10)
1. Assemble the mount assembly by inserting a carriage
bolt (M) into the upper hole of a mount bracket
assembly (10) as shown.
2. On the left-side of the mount assembly (9), insert the
carriage bolt into the inside slot.
3. Secure the mount bracket assembly with a washer (L)
and NYLOC hex nut (F) and tighten.
4. On the right-side of the mount assembly (9), insert a
hex bolt (M) into the lower hole of the mount bracket
assembly (10) and into the inside slot of the mount
bracket assembly as shown.
5. Secure the mount bracket assembly with a washer (L)
and NYLOC hex nut (F) and tighten.
Fig. 10
10
M
Step 2: (figure 11)
1. Attach the mount assembly (9) to the tractor using two
self-tapping hex bolts (O) with washers (L).
2. Place a side-mount plate (13) on each side as shown,
and attach using a hex bolt (J) from the inside of the
tractor frame.
3. Secure each bolt with a flat washer (L) and Nylock hex
nut (F).
4. Proceed to "Attach Tool Rack to Mount Assembly" on
page 6.
Fig. 11
9
ENglISh
F
L
9
L
O
F
L
13
J
5
Publicidad
