Publicidad
Idiomas disponibles
Idiomas disponibles
ENglISh
AttACH tOOL rACK tO mOUnt ASSemBLy
This section is applicable to Craftsman, Husqvarna, and John
Deere 100 Series lawn tractors.
Step 1 (figure 12)
1. Insert the lower support assembly (12) into the tube on
the mount assembly.
2. Align the holes in the lower support assembly and insert
the clevis pin (Q) through the holes as shown.
3. Insert the hair pin cotter (R) through the hole in the
clevis pin.
4. Secure the lower support assembly with a hex bolt (X)
with loc washer (P).
Fig. 12
Q
Step 2 (figure 13)
1. On the tool rack, temporarily remove the two hex
nuts (F) securing the bottom tool holder assembly (2).
2. Place the tool rack so that the bolts in the tool holder
assembly are inserted into the two holes on top of the
lower support assembly (12) as shown.
3. Reinstall the hex nuts (F) on each bolt and tighten.
4. Continue to "Attach Bed Assembly to Tool Rack Frame"
Fig. 13
6
12
X
P
2
12
AttACH BeD ASSemBLy tO tOOL rACK
frAme
This section is applicable to Craftsman, Husqvarna, and John
Deere 100 Series lawn tractors.
Step 1 (figure 14)
1. Attach the bed assembly (7) by placing the two bag
mount brackets (8) onto the mount assemblies (6) as
shown, allowing the bolt to pass through the slot in the
bag mount bracket.
2. Secure each bag mount bracket with a wing knob (V)
and hand tighten.
Fig. 14
R
8
Step 2 (figure 15)
1. Loop the support cable over the washer on the tool rack
frame as shown.
2. Repeat with the other support cable.
Fig. 15
F
6
7
L,Z,L,V
V
Publicidad
