Chapter 12 - Correct Use And Tips; Chapter 13 - Routine Maintenance - Lavorwash SWL R 1100 DT Manual De Istrucciones

CHAPTER 12 - CORRECT USE AND TIPS

IMPORTANT: Before starting operation, check for cords, plastic or metal wires or long
rags, sticks, power cords etc on the surface; these are dangerous and could damage
the dust washers and brooms. It is therefore necessary to remove them before
operating the machine.
•
Be very careful when driving over rails, or door guides etc . as they are the greatest source of damage to
the dust washers, as they must pass over them, it is necessary to drive very slowly .
•
Avoid driving over puddles.
•
When there are bulky or light objects to collect (leaves, cigarette packs, etc.) lift the front fl ap by
pressing the fl ap-lift pedal with your LT foot Detail 2 Fig. 7.
•
If the surface requiring cleaning is very dirty in terms of amount or type of material or dust to collect,
it is advisable to carry out an initial "rough" cleaning, without taking into account the fi nal result, then,
with the hopper emptied out and the fi lters well-shaken, clean the surface again; accordingly, you will
obtain the required result .
•
Following this procedure, by using the machine at regularly and at the right times, it will no longer be
necessary to carry out the "rough" cleaning procedure .
•
The side broom must only be used to clean edges, profi les, corners, etc. It must be lifted (disabled)
immediately after use to avoid raised unnecessary dust, and also because the results obtained with the
side broom enabled is never as good as operation with the central broom only .
•
For good results, empty out the hopper often and keep the fi lters clean by shaking them with relative
tools .

CHAPTER 13 - ROUTINE MAINTENANCE

ANY MAINTENANCE AND CLEANING OPERATION MUST BE CARRIED OUT WITH
THE START KEY REMOVED AND WITH THE ENGINE OFF AND COLD, IN THE
CASE OF ENDOTHERMIC VERSIONS OF THE MACHINE, AND WITH THE BATTERY
DISCONNECTED, IN THE BATTERY POWERED VERSIONS.
Press the button Detail 1
Fig.11 to make the filter
vibrate prior to operation
and prior to emptying out
the debris hopper, for 5/6
cycles of 3/4 seconds each.
Every 60/100 hours of
operation, or whenever
necessary, check the dust filter
Detail C Fig. 13, by removing
it from its casing, pulling out
the debris hopper, disconnecting
the connector Detail A Fig. 13,
unscrewing the four screws from
the clamping brackets Detail B
Fig. 13 . Accordingly, the filter
(always in conjunction with
the vibrator) can be removed
from the machine and cleaned
with compressed air from the
inside out . When putting it back
in place, make sure it stands
firmly against the black sealing
washer . Make sure that the filter
is always in excellent conditions
and change it whenever
necessary .
CLEANING BAG DUST FILTERS (standard version)
43