Publicidad
Idiomas disponibles
Idiomas disponibles
4.5 Fuel optimisation
Excellent fuel depends on different factors (type of installation, operating and maintenance
conditions, type of pellets, etc.)
Generally speaking, if at the end of combustion, there is a lot of residue in the burn pot, you
should change the combustion configuration (by increasing the value) until you find the best
solution.
a) Use the
arrow keys to go to the set-up menu
b) Select the password "7" with the
c) Scroll with the
1
"
"
2
"
"
3
"
"
d) Press the key
to confirm the set data.
5
USING THE STOVE
5.1
Power on
Before each ignition, make sure that the burn pot is completely empty and correctly positioned
in its seat.
To turn on the stove keep the
The flame icon will start to flash, during the ignition phase until it remains fixed when the stove is on.
Automatic ignition: the stove is equipped with an automatic device that allows pellet ignition
without the use of other traditional ignitors.
Avoid manually turning on the stove if the automatic ignition system is compromised.
The first time you light the stove, smoke and unpleasant odours might form and escape due
to the evaporation or drying of some of the materials used. This phenomenon will gradually
disappear.
During the first ignitions, it is advisable to keep the premises well ventilated.
5.2 Switching off
To switch off the stove, keep the
To switch it on again, it is advisable to wait for the stove to cool completely.
It is advisable to turn off the stove strictly following the above and always avoid doing so by un-
plugging it from the power supply.
004779080 - 26/08/2022
ITALIANO
ENGLISH
key and confirm with the
key and select the submenu
key pressed for a few seconds.
key pressed for a few seconds; the flame icon will go out.
FRANÇAIS
DEUTSCH
and press the
key;
key;
[14]
and confirm with the
ESPAÑOL
key;
21
Publicidad
