Ashdown Engineering 12-BAND 600 Manual De Instrucciones página 8

ASHDOWN ENGINEERING - 12-BAND 600
USER GUIDE
MUTE/TUNE - The front panel MUTE switch provides a mute facility that can be
used to silence all outputs from the amplifier except that from the TUNER output
socket. This enables silent tuning to be carried out whilst the amplifier speaker
outputs, the DI the Effects Send and the Line Output are all muted. Once in tune the
amplifier can be un- muted and playing resumed. This switch can also be used as
a STANDBY switch for silencing the amplifier during pauses in its use. A blue LED
below this switch will illuminate to indicate when the amplifier is Muted.
To make use of the Tuning facility plug the output from the TUNER socket into the
INSTRUMENT input on your tuner.
OUTPUT LEVEL - The OUTPUT LEVEL control is used to set the stage volume of
the amplifier. Use this control to adjust for increases or decreases in your playing
volume and not the INPUT GAIN control, this should always be left set to the
optimum for your instrument.
LINE OUTPUT - The LINE output is for connection to external power amplifiers and
speakers to allow you to build a larger more powerful system. This output is situated
after the OUTPUT LEVEL control to allow the entire connected system to be turned
up and down with a single control.
If you require a line output that is not affected by the OUTPUT LEVEL control you
may use the EFFECTS SEND jack socket, this will obviously not include any effects
loop signal.