FujiFilm SonoSite X-Porte Manual Para El Usuario página 24

d To complete the trace, lift your finger from the screen.
The trace closes automatically.
Note:
e You can adjust the centerline by dragging the centerline cursor.
Note:
f To save the calculation, tap
Note:
To measure peak velocity
The Save Set button is no longer needed and has been removed. Use the revised procedure below:
1 On a frozen Doppler spectral trace, tap
Calcs
If this control is hidden, tapping
2 For each calculation you want to perform, on the calculation list, choose
Vein and then do the following:
If the calculation list is not visible, tap
3 Tap the measurement name.
4 Position the calipers.
To make a correction, trace backward on the dotted line.
In some measurements, you can click
5 To save the calculation, tap
6 Repeat steps 3 through 6 for each calculation you want to perform.
To calculate the Aortic Valve Area (AVA)
The AVA calculation requires a measurement in 2D and two measurements in Doppler. After the
measurements are saved, the result appears in the patient report.
22
Even after completing the trace, you can still adjust it by dragging the cursor
backward on the dotted line.
The recommended method is to trace from annulus to annulus and allow the
system to automatically close the trace. If the start and end trace points are too
close together, the centerline adjustment function may be limited.
under the measurement name.
To calculate LAVI and/or RAVI, BSA is required.
Calcs
More Controls
Next
to change to the next measurement.
under the measurement name.
.
displays it.
at the top of the current list.
MV/MR , TV/TR , TDI , or P