Operation - Craftsman CX Serie Manual Del Operador

GAS AND OIL FILL-UP
IMPORTANT: The engine is shipped without gasoline and with motor oil in the
engine. However, you MUST check the oil level before operating. Be careful not to
overfill. Running the engine with insufficient oil can cause serious engine damage
and void the engine warranty.
Oil Recommendations
Before starting engine, check oil level, capacity is 1700 ml/57.5 fl. oz. Refer to
viscosity chart below for oil recommendations. Do not over-fill. Use a synthetic or
non-synthetic 4-stroke, or an equivalent high detergent, premium quality motor
oil certified to meet or exceed U.S. automobile manufacturer's requirements for
service classification SG, SF. Motor oils classified SG, SF will show this designation
on the container.
SAE 10W-30 is recommended for general, all temperature use. If single viscosity oil
is used, select the appropriate viscosity for the average temperature in your area
from the chart below.
5W-30
(ºC)
-30º -20º -10º
(ºF)
-20º 0º 15º 30º
CAUTION: Do not use non-detergent oil or 2-stroke engine oil. It could shorten the
engine's service life.
NOTE: A 5w30 synthetic oil may be used to improve start ability for cold weather
(temperatures below 400 F).
Checking Oil Level
NOTE: Be sure to check the oil while on a level surface with the engine stopped.
1. Remove the oil filler cap/dipstick and wipe the dipstick clean.
2. Insert the dipstick into the oil filler neck. Turn the dipstick a 1/4 turn into the
locked position to fully seat. See Figure 11.
3. Remove dipstick to check the oil level.
4. If the level is low, slowly add oil to the upper limit on the dipstick. See Figure
11 inset.
5. Reinsert the dipstick and turn to locked position before starting the engine.
NOTE: Do not overfill. Overfilling with oil may cause smoking, hard starting,
spark plug fouling, or oil saturation of air cleaner.

OPERATION

30
Synthetic 5W-30
10W-30
0º 10º 20º 30º 40º
50º 70º 85º 105º
Oil Fill
Cap/Dipstick
Upper
Level
Gasoline Requirements
Operating the engine with E15 or E85 fuel, an oil/gasoline mixture, dirty
gasoline, or gasoline over 30 days old without fuel stabilizing additive may
result in damage to your engine's carburetor. Subsequent damage would
not be covered under the manufacturer's warranty.
Use automotive gasoline (unleaded or low leaded to minimize combustion chamber
deposits) with a minimum of 87 octane. Gasoline with up to 10% ethanol (E10)
or 15% MTBE (Methyl Tertiary Butyl Ether) can be used. Never use an oil/gasoline
mixture or dirty gasoline. Avoid getting dirt, dust, or water in the fuel tank. DO NOT
use E15 or E85 gasoline.
Gasoline is extremely flammable and is explosive under certain conditions.
• Refuel in a well-ventilated area with the engine stopped. Do not smoke or
allow flames or sparks in the area where the engine is refueled or where
gasoline is stored.
• Do not overfill the fuel tank. After refueling, make sure the tank cap is closed
properly and securely.
• Be careful not to spill fuel when refueling. Spilled fuel or fuel vapor may
ignite. If any fuel is spilled, make sure the area is dry before starting the
engine.
• Avoid repeated or prolonged contact with skin or breathing of vapor.
Adding Gasoline
An adult should fuel this engine. NEVER allow children to refuel the engine.
Gasoline (fuel) vapors are highly flammable and can explode. Fuel vapors
can spread and be ignited by a spark or flame many feet away from engine.
To prevent injury or death from fuel fires, follow these instructions:
• DO NOT use leaded fuel.
13
Figure 11
CAUTION
WARNING
WARNING