Manual Settings - Emos E8670 Manual De Instrucciones

8. Rainwater must be able to continuously and freely flow out of the sensor. Always check that
water is not accumulating in the bottom of the sensor.
9. When choosing a suitable place to mount the sensor, check that the main station is within
range of the sensor. The range of the sensor may decrease substantially in areas with a large
number of obstacles.
10. Do not place the sensor onto metal objects; doing so will reduce the transmission range.
11. If the low battery icon
or weather station.
Radio-Controlled Clock (DCF77)
After being registered by the wireless sensor, the weather station will automatically start searching
for DCF77 signal (DCF for short) for 7 minutes; the
on the display will be updated and the buttons will be disabled (except SNOOZE/LIGHT). Once the signal
is detected, the icon will stop flashing (
no signal is detected, the DCF icon will not be shown.
Long-press the DOWN button to search for DCF signal again. To cancel the search for signal, long-
press the DOWN button again. DCF signal will be synchronised daily between 2:00 and 3:00 am.
During daylight saving time, the
Note: If the weather station detects DCF signal but the current time on the display is incorrect (e.g.
shifted ±1 hour), you must set the correct time zone for the country where you are using the station,
(see Manual Settings).
In standard conditions (at safe distance from sources of interference, such as TV sets or computer
monitors), the reception of time signal takes several minutes.If the weather station does not detect
the signal, follow these steps:
1. Move the weather station to another location and try to detect the DCF signal again.
2. Check the distance of the clock from sources of interference (computer monitors or television
sets). The distance should be at least 1.5 to 2 m during the reception of signal.
3. When receiving DCF signal, do not place the weather station near metal doors, window frames
and other metal structures or objects (washing machines, dryers, refrigerators, etc.).
4. In reinforced concrete structures (cellars, high-rise buildings, etc.), the reception of DCF signal
is weaker, depending on the conditions. In extreme cases, place the weather station close to a
window in the direction of a transmitter.
Reception of DCF radio signal is affected by the following factors:
• thick walls and insulation, basements and cellars;
• inadequate local geographical conditions (these are difficult to assess in advance);
• atmospheric disturbances, thunderstorms, electrical appliances with no interference elimination,
television sets and computers located near the DCF receiver.

Manual Settings

1. Long-press the MODE button.
2. Then, repeatedly press the MODE button to choose settings for: time zone – 12/24 h – hours
– minutes – year – month – day. You can navigate between the values by pressing the MODE
button, set values using UP/DOWN.
The calendar is in English.
Setting °C/°F Temperature Unit
Repeatedly pressing the UP button switches temperature units between °C/°F.
Setting Unit of Pressure/Precipitation
Repeatedly pressing the DOWN button sets the pressure and precipitation units to inHg/inches or
hPa/mm.
Atmospheric Pressure
The current pressure value is displayed in field no. 17.
Repeatedly pressing the DOWN button sets the unit of pressure to inHg or hPa.
is displayed on the station's screen, replace batteries in the sensor
icon flashes. During the search, no other items
stays on the screen) and current time will be displayed. If
icon will be displayed.
6