Publicidad
1.
Remove the plastic cover, if present, from the positive battery
terminal and attach the red cable to the positive battery terminal
(+) with the bolt and hex nut. See Figure 7.
2.
Remove the plastic cover, if present, from the negative battery
terminal and attach the black cable to the negative battery
terminal (–) with the bolt and hex nut. See Figure 7.
3.
Position the red rubber boot over the positive battery terminal to
help protect it from corrosion.
NOTE: If the battery is put into service after the date shown on top or side
of battery, charge the battery as instructed in the Service and Maintenance
section your Operator's Manual prior to operating the riding mower.
Adjusting the Seat
To adjust the position of the seat, pull up and hold the seat adjustment
lever. Slide the seat forward or rearward to the desired position; then
release the adjustment lever. Make sure seat is locked into position
before operating the riding mower. See Figure 8.
ASSEMBLY
Figure 7
Figure 8
Checking and adding oil
NOTE: Your riding mower is shipped with oil in the engine. However,
you MUST check the oil level before operating.
1.
Place the riding mower on a flat, level surface.
2.
Remove the oil filler cap/dipstick and wipe the dipstick clean. See
Figure 9.
3.
Insert the cap/dipstick into the oil filler neck, but do not screw it in.
4.
Remove the oil filler cap/dipstick. If the level is low, slowly add oil
until oil level registers between full (F) and low (L), Figure 9.
NOTE: Do not overfill. Overfilling with oil may cause smoking, hard
starting, or spark plug fouling.
5.
Replace and tighten cap/dipstick firmly before starting engine.
NOTE: DO NOT allow oil level to fall below the "L" mark on the
dipstick. Doing so may result in equipment malfunctions or damage.
NOTE: To change the oil in your engine, see the Service and
Maintenance section of this manual.
11
Fill
between
full
and low
marks
Figure 9
Publicidad
Solución de problemas
