How To Unlock The Kp200 As Admin - Kingston IronKey Keypad 200 Manual Del Usuario

To create an Admin PIN in User mode, proceed with the following steps.
Instructions
1. Unlock the KP200 with your User PIN
2. Press and hold down the number 1 button
and press the KEY button twice (double click)
(1 & )
3. Enter your new 8-15 digit Admin PIN
4. Press KEY button twice (double click)
5. Re-enter your new Admin PIN
6. Press KEY button twice (double click)

12. How to Unlock the KP200 as Admin

Caution:
Entering the Admin PIN to access a locked drive will clear (delete) the User PIN.
Instructions
1. Press and hold down the number 1 button
and press the KEY button once (1 &
2. Enter your Admin PIN
3. Press the KEY button once
Note:
Once the KP200 has been successfully unlocked, the
seconds only, during which time the KP200 needs to be connected to a powered USB port. It can be
locked down immediately (if not connected to a USB port) by pressing and holding down the KEY button
for 3 seconds, or by clicking the 'Safely Remove Hardware/Eject' icon within your operating system
when connected to a USB port.
When the KP200 is unlocked and connected to a USB port, it will not accept further instructions via the keypad.
#12
LED LED State
Green
successful User PIN entry
Solid
Red
Red
together
Red
Green
Green
Blinking
Red
LED indicating the Admin PIN has been
successfully configured
LED LED State
Red,
) and then
Red
Flickering
to a solid
flickering
Admin PIN entry- drive unlocked as Admin
Green LED will remain on and blinking for 30
www.kingston.com
LED will be solid indicating
Green LED will switch to flickering
and Blue LEDs
and Blue LEDs will continue to flicker
and Blue LEDs will switch to a blinking
LED
LED will continue to blink
Green LED will change to a solid
LED before switching to a solid
Green & Blue LEDs will flash together once
Red and Green LEDs flicker together
and Green LEDs continue to flicker together
Red and Green LEDs will change
Red LED and then switch to a
Green LED indicating successful
Green