Publicidad
Idiomas disponibles
Idiomas disponibles
5. How to Access Drive Settings in User Mode
The drive settings mode will allow the user to perform different functions such as creating an Admin PIN, enabling
and disabling the KP200 as Read-Only, setting a Timeout lock and determining the device version number.
The table below illustrates how to access the drive settings mode, sections 6-11 describe how to perform the
various functions.
Instructions
1. Press KEY button once
2. Enter your current User PIN
3. Press the KEY button once
4. Press the KEY button three times- (triple-click)
6. How to Enable Read-Only as User
To set the KP200 to Read-Only in User mode, proceed with the following steps.
Instructions
1. Unlock the KP200 with your User PIN
2. Press the KEY button three times- (triple-click)
3. Press button number 7 followed by the
number 6 button - (76)
4. Press the KEY button once
Note:
Once activated, drive access is limited to Read-Only. When KP200 is unlocked and inserted into a
USB port the
Green
LED blinks every two seconds indicating the drive is in Read-Only Mode. Admin can
override User Read/Write settings by enabling/disabling Read/Write in Admin mode.
#8
LED
LED State
Red,
once and then the
blink.
blink together if an Admin PIN also exists.)
Red
Solid
LED indicating successful User PIN entry
Solid
and
new user defined drive settings
LED
LED State
Green
User PIN entry
Solid
Green
is awaiting new user defined settings
Green
Green
Red
indicating successful Read-Only configuration
www.kingston.com
Green
&
Blue
LEDs will flash together
Red
LED will continue to
(Note:
Both
RED
and
Blue
LED will continue to blink
Red
LED switches to a solid
Green
LED switches to blinking
Blue
LEDs, indicating the drive is awaiting
LED will be solid indicating successful
Green
LED switches to blinking
and
Blue
LEDs indicating the drive
and
Blue
LEDs will continue to blink
and
Blue
LEDs will change to a solid
LED before switching to a solid
LEDs will
Green
Green
Green
LED
Publicidad
