Kingston IronKey Keypad 200 Manual Del Usuario página 21

KEYPAD 200
25. How to Create a User PIN After a Brute Force Attack or Reset
It will be necessary after a Brute Force attack or when the KP200 has been reset to create a new User PIN
and format the drive before it can be used. To create an Admin PIN instead of a User PIN, refer to section 26.
PIN Requirements:
• Must be between 8-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7-8), (7-8-9-0-1-2-3-4), (8-7-6-5-4-3-2-1)
To create a User PIN after a Brute Force attack or Reset, proceed with the following steps.
Instructions
1. Press KEY button once
2. Press the KEY button twice (double-click)
3. Enter your new 8-15 digit User PIN
4. Press KEY button twice (double-click)
5. Re-enter your new User PIN
6. Press KEY button twice (double-click)
26. How to Create an Admin PIN After a Brute Force Attack or Reset
It will be necessary after a Brute Force attack or when the KP200 has been reset to create a new Admin PIN
and format the drive before it can be used. To create a User PIN instead of an Admin PIN, refer to section 25.
PIN Requirements:
• Must be between 8-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7-8), (7-8-9-0-1-2-3-4), (8-7-6-5-4-3-2-1)
#20
LED LED State
Red,
together once and then switch to a solid
Red
Solid
switch to a blinking
Blue
Blinking
Green
Green
Blinking
Red
LED indicating that the User PIN was
successfully created
www.kingston.com
Green & Blue LEDs will flash
LED and a blinking Green
Red LED and blinking Green
Blue LED
LED will continue to blink
Blue LED will switch to a blinking
LED
LED continues to blink
Green LED will change to solid
LED and then switch to a solid
LED
LED will
Green