How To Enable Read-Only In Admin Mode; How To Enable Read/Write In Admin Mode - Kingston IronKey Keypad 200 Manual Del Usuario

17. How to Enable Read-Only in Admin Mode

When Admin writes content to the KP200 and restricts access to read-only, the User cannot change this
setting in User mode.
To set the KP200 to Read-Only, please follow the steps below.
Caution:
Entering the Admin PIN to access a locked drive will clear (delete) the User PIN.
Instructions
1. Unlock the KP200 with your Admin PIN
2. Press the KEY button three times
(triple-click)
3. Press the number 7 button followed by the
number 6 button (76)
4. Press KEY button once

18. How to Enable Read/Write in Admin Mode

Admin can override User set Read-Only by enabling Read/Write using the Admin PIN.
To set the KP200 to Read/Write, please follow the steps below.
Caution:
Entering the Admin PIN to access a locked drive will clear (delete) the User PIN.
Instructions
1. Unlock the KP200 with your Admin PIN
2. Press the KEY button three times
(triple-click)
3. Press the number 7 button followed by the number
9 button (79)
4. Press KEY button once
LED LED State
Green
Admin PIN entry
Green
Green
together
Green
Red
Green
into a USB port the
every two seconds indicating the KP200 is
in Read-Only mode
LED LED State
Green
Admin PIN entry
Green
Green
together
Green
LED and then switches to a flickering
LED. When the KP200 is inserted into a USB
port the
KP200 is Read/Write enabled
#15 www.kingston.com
www.kingston.com
LED will flicker indicating successful
and Blue LEDs flicker together
and Blue LEDs continue to flicker
and Blue LEDs change to a solid
LED and then switches to a flickering
LED. When the KP200 is inserted
Green LED blinks
LED will flicker indicating successful
and Blue LEDs flicker together
and Blue LEDs continue to flicker
and Blue LEDs change to a solid
Green LED is solid indicating the
Red
Green
#15