How To Use The Kp200 For The First Time - Kingston IronKey Keypad 200 Manual Del Usuario

3. How to Use the KP200 for The First Time

The KP200 is supplied in the 'Initial Shipment State' with no pre-set PIN. An 8-15 digit User PIN must be
configured before the drive can be used. Once a User PIN has been successfully configured, it will then not
be possible to revert the drive back to the 'Initial Shipment State'.
PIN requirements:
• Must be between 8-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7-8), (7-8-9-0-1-2-3-4), (8-7-6-5-4-3-2-1)
Password Tip: You can create a memorable word, name, phrase or any other Alphanumerical PIN
combination by simply pressing the key with the corresponding letters on it.
Examples of these types of Alphanumerical PINs are:
• For "Password" you would press the following keys:
7 (pqrs) 2 (abc) 7 (pqrs) 7 (pqrs) 9 (wxyz) 6 (mno) 7 (pqrs) 3 (def)
• For "IronKey1" you would press:
4 (ghi) 7 (pqrs) 6 (mno) 6 (mno) 5 (jkl) 3 (def) 9 (wxyx) and then 1
Using this method, long and easy to remember PIN's can be created.
To create a User PIN, proceed with the following steps.
Instructions
1. Press KEY button once
2. Press the KEY button twice (double-click)
3. Enter your new 8-15 digit User PIN
4. Press KEY button twice (double-click)
5. Re-enter your new User PIN
6. Press KEY button twice (double-click)
Note:
Once the KP200 has been successfully unlocked, the
state for 30 seconds only, during which time the KP200 needs to be connected to a powered USB port.
It can be locked down immediately (if not connected to a USB port) by pressing and holding down
the KEY button
operating system when connected to a USB port. When the KP200 is unlocked and connected to a USB
port, it will not accept further instructions via the keypad.
#6
for 3 seconds, or by clicking the 'Safely Remove Hardware/Eject' icon within your
LED LED State
Red,
once and then switch to a solid
blinking
Solid
LEDs will switch to a blinking
Blue
Blinking
Green
Green
Blinking
LED and then switch to a solid
indicating that the User PIN was successfully
created
Green LED will remain on and in a solid
www.kingston.com
Green & Blue LEDs will flash together
Green and Blue LEDs
Red LED and blinking Green
Blue
LED will continue to blink
Blue LED will switch to a blinking
LED
LED continues to blink
Green LED will change to solid
Red LED and
and Blue
LED
Red
Green LED