Publicidad
Idiomas disponibles
Idiomas disponibles
ascaso
UNO PID model
1. Turn on the general switch
pilot lights come on
flash. The PID system screen
shows the temperature rise.
2. When the pilot light
flashing and the screen
the pre-set coffee temperature,
turn on the steam switch
The pilot light
indicating the heating process to
steam temperature. The screen
will flash the pre-set steam
24
temperature.
3. Turn on the hot water/steam knob
4
and let water flow until it is
running continuously. Turn it off.
4. Wait for the pilot light to
on without flashing This shows that
the water has reached the right
temperature. The temperature
value will also be shown steadily
on the screen
start to work in bursts. When this
happens, turn on the knob again
to obtain steam
NB!
The pilot light
faster for about 10 seconds before
steam is generated. Use this signal to
turn the knob on
5. Immerse about half of the steam
wand in the milk
6. When finished, turn both the water/
steam knob
switch
3
7. If you want to obtain more than
three consecutive cappuccino
services, or make more coffee
afterwards, see sections 2B and
2C.
NB!
The steam generation
system includes a safety limit that
cuts off the service after 3 minutes of
continual operation.
NB!
When the steam service is
finished, the machine temperature will
be too high to make coffee. The pilot
36
MAN.38 V8 - MANUAL STEEL-STEEL PID 2022.indd 36
MAN.38 V8 - MANUAL STEEL-STEEL PID 2022.indd 36
The
1
13
, and
6
24
stops
6
shows
24
3
.
15
will flash,
come
15
24
. The pump will
.
4
15
will flash
.
4
to heat it.
5
4
and the steam
off.
light
will flash until the machine
6
returns to the correct temperature at
which point the screen
pre-set coffee temperature. Follow
point 2.B to force cooling.
DUO models
1. Make sure that the main switch
is in position (II).
2. Press button
. The pilot light
3
comes on.
3. Open the steam knob
steam. Whenever the switch is
turned on
the pilot light comes
3
on
15
.
4. Without turning the switch on,
the pilot light
3
15
at intervals. This does not affect
its use as the temperature is
automatically regulated.
5. Immerse about half the steam
wand
5
in the milk to heat it.
6. When finished, close the switch
and the steam knob
NB!
After each use it is
advisable to release steam for 5
seconds to clean the tube and
prevent blockage. You can use
a toothpick or clip to clean the
absorption hole. Make sure the nozzle
is free of obstructions.
DUO PID models
1. Turn on the general switch
pilot lights come on
flash. The PID system screen
shows the temperature rise.
NB!
Check that the steam
generation system is on (see section
6 of this manual). Once activated,
the steam generation system starts
heating to the required temperature.
2. When the pilot light
flashing and the screen
the pre-set coffee temperature,
turn on the steam switch
If the temperature of the steam
generation system has not yet
flashes the
24
1
15
to get
4
will come on
3
.
4
The
1
, and
13
6
24
stops
6
shows
24
.
3
06/09/2022 9:25:26
06/09/2022 9:25:26
Publicidad
