Lamp Replacement - Acuity Brands HOLOPHANE CORTEZ CZQ2L Manual Del Usuario

LAMP REPLACEMENT

Remove lamp bezel as shown
1
below.
Bezel
Collar
Carefully flex this edge &
free from collar button
CHARGER BOARD REPLACEMENT
With the unit oriented as in the below
1
view, flex the channel at the left end
of the charger board outward to
release and remove it. Unplug the
battery and other connections. See
"Lamp Replacement" above, to
disconnect the lamp wires from the
charger board.
TESTING and MAINTENANCE (CONTINUED)
Gently bend the snap at each side of
2
the collar outward to release the
lamp assembly. Cut wires near lamp
board and strip back 1/4in. Connect
stripped wires to the replacement
lamp, following the yellow/blue
polarity as marked.
Collar button
Connect the lamp wires to the new
2
charger board, following the
yellow/blue polarity as marked.
Reconnect the battery and other
components (if included). For insertion
of PCB, insert right side (1) of PCB
first, followed by left side (2) (click
should be heard).
Release snaps
gently
Connector under
the PCB
2
1
Replace the lamp assembly firmly
3
under the snaps on the collar,
making sure the lamp wires are not
pinched. Replace the bezel.
Yellow
Blue
(-)
Cut wires near
Lamp board
Make sure all wires are routed as
3
before, so as not to interfere with
proper assembly of the housing
onto the mounting plate. Re-
assemble the unit (see also step 5
& 6, page 3).
page 5
(+)