Levenhuk Wezzer Tick H50 Guia Del Usuario página 4

Levenhuk Wezzer Tick H50 Clock-thermometer
EN
The kit includes: base station, USB cable, user manual, and warranty.
Caution! Please remember that mains voltage in most European countries is 220–240V. If you want to use your device in a country
with a different mains voltage standard, remember that use of a converter is absolutely necessary.
Getting started
•
Connect the power cable to the device and the DC adapter (not included) via a USB plug and connect to the AC power supply; or
•
Open the battery compartment cover (16) and insert a battery according to the correct polarity. Close the cover.
NOTE! It is recommended to use an adapter for the continuous operation of the base station, although battery power is also
possible.
Time setting
Press the SET button and hold it for 3 seconds. The digits that are to be set are flashing. Press UP/PROJECT or DOWN to change the
value, and then press SET to continue.
The setting order: 12/24h > Hours > Minutes.
Finally, press the SET button to save the settings and exit.
Alarm setting
•
Press the AL button to set the Alarm 1.
•
In the alarm setting mode press and hold the AL button for 3 seconds. The digits that are to be set are flashing. Press the UP/
PROJECT button or DOWN button to change the value, and then press the AL button to continue.
The setting order: Hours > Minutes > Snooze time > Alarm sound. Press the AL button to confirm the settings and exit.
•
Repeat the instructions above to set the Alarm 2.
•
To activate or deactivate the Alarm 1 and/or Alarm 2, press the DOWN button in normal mode.
The order: AL1 On > AL2 On > AL1 + AL2 On > AL1 + AL2 Off.
•
To silence the alarm, press any button (except the SNZ/LIGHT button). The alarm sound will automatically turn off after 2 minutes.
Snooze function
When the alarm sounds, press the SNZ/LIGHT button to activate the snooze function. The alarm will sound again in a preset time
span.
Alarm sound
When setting the alarm, you can choose either buzzer (the display shows "bu") or radio (the display shows "rd") as the alarm sound.
Temperature setting
Press the DOWN button to switch between °C and °F.
Projection setting
•
Press the UP/PROJECT button to turn on the projection, and then press it again to choose the projection brightness (3 levels
available).
•
Press and hold the UP/PROJECT button to change the projection degree (0° > 90° > 180°).
Backlight setting
•
Press the SNZ/LIGHT button to choose the brightness (4 levels available).
•
Press and hold the SNZ/LIGHT button for 3 seconds to turn on/off the Auto mode. The display will automatically lower its
brightness level when it is dark.
Night mode
•
Press the SET button, and then press the UP/PROJECT button or DOWN button to turn on/off the Night mode. The display
brightness will be lowered during a scheduled time span.
4