Össur 4SEAL LINER Manual Del Usuario página 7

Art.No. Description
1820610 Flex EVA weiß 400x400x10 mm
1820612 Flex EVA weiß 400x400x12 mm
1820615 Flex EVA weiß 400x400x15 mm
1820510 Flex EVA natur 400x400x10 mm
1820512 Flex EVA natur 400x400x12 mm
1820515 Flex EVA natur 400x400x15 mm
1820412 Plex 400x400x12 mm
1820415 Plex 400x400x15 mm
1820420 Plex 400x400x20 mm
Regardless of the socket material, the inner socket wall should be as smooth as possible. With laminated sockets,
use a double layer of Dacron felt, or something similar, to achieve a smooth socket interior.
To achieve a smooth surface on the plaster model, we recommend the use of silicone spray.
Make sure that the valve is incorporated as distally as possible and always below the seals.
Fit
• Can the user put the socket on easily?
Volume
• Is there full contact between the seals and the inner socket wall?
• Do air pockets develop when under a load? How good is the proximal fit?
Adhesion
• Is there any pistoning in the socket?
• Is there any visible movement when pulling on the prosthesis?
• Is there rotational stability?
• Is full movement possible without affecting the suction?
Volume compensation sleeve:
In the case of fluctuations in the volume of the patient's residual limb that do not lead to loss of vacuum in the
area of the seals, you can use these special volume sleeves to compensate for this volume above the seals. They
are available in 3 sizes:
Art. No size
1.880.010 S
1.880.011 M
1.880.012 L
Art. No size
1.880.010 S
1.880.011 M
1.880.012 L
Length For liner size (TFS)
24 cm 26,5 – 32
24 cm 34 – 40
24 cm 45 – 50
Length For liner size (TFC)
24 cm 25 – 28
24 cm 30 – 34
24 cm 36 – 40
7