Assembly; To Attach The Cutting Deck - Husqvarna R 418TsX AWD Manual De Usuario

• The ignition key is removed.
• The cutting deck is disengaged.
• The ignition cables are removed from the
plugs.
WARNING:
the engine contain carbon monoxide, an
odourless, poisonous and very dangerous
gas. Do not run the product in closed spaces
or spaces with not sufficient air flow.
WARNING:
instructions that follow before you use the
product.
• For best performance and safety, do maintenance
on the product regularly as given in the maintenance
Maintenance schedule on page 109 .
schedule. See
• Electrical shocks can cause injuries. Do not touch
the cables when the engine is on. Do not do a
function test on the ignition system with your fingers.
• Do not start the engine if the protective covers are
removed. There is a high risk of injury caused by
moving or hot parts.
Introduction
WARNING:
safety chapter before you assemble the
product.

To attach the cutting deck

1. Park the product on level ground.
2. Apply the parking brake.
3. Set the lift lever for the cutting deck in transport
position.
104
The exhaust fumes from
Read the warning

Assembly

Read and understand the
• Let the product become cool before you do
maintenance near the engine.
• The blades are sharp and can cause cuts. Wind
protection around the blades or use protective
gloves when you do work on the blades.
• Always put the cutting deck in servicing position to
clean it. Do not park the product near the edge of a
ditch or slope to get access to the cutting deck.
CAUTION:
instructions that follow before you use the
product.
• Do not turn over the engine if the spark plug or
ignition cable is removed.
• Make sure that all nuts and bolts are tightened
correctly and that the equipment is in good condition.
• Do not change the adjustment of governors. If the
engine speed is too high, the product components
can become damaged. See
129 for highest permitted engine speed.
• The product is approved only with the equipment
supplied or recommended by the manufacturer.
4. Move the weight transfer lever up to disengage the
weight transfer.
5. Set the lift lever for the cutting deck in the mow
position.
6. Stop the engine.
7. Set the cutting height lever to the servicing position.
Read the caution
Technical data on page
880 - 009 - 31.10.2022