Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Replace the transmission filter (for AWD models only).
Replace the spin on filter for the servo (if applicable).
Do a check of the cooling fan on the hydrostatic transmission.
Do a check of the oil in the transmission and fill if it is necessary. Refer to
a check of the transmission oil level on page 121 .
Replace the oil in the transmission.
Examine and adjust the parking brake.
Clean the outer and inner surfaces of the cutting deck and the cutting deck
To clean the product on page 111 .
covers. Refer to
Do a check of and adjust the cutting height and pitch setting. Refer to
a check of the parallelism of the cutting deck on page 117 and To adjust the
parallelism of the cutting deck on page 117 .
Examine the blades in the cutting deck, sharp and balance if necessary. Refer to
To examine the blades on page 119 and To replace the blades on page 119 .
Do a check of and adjust the engine RPM.
Make sure that the product does not move in neutral position. Refer to
check of the forward pedal and rearward pedal on page 102 .
Do a check of the forward drive and the rearward drive on different speeds.
Do a check of the blade engagement, seat, lift and forward drive/brake. Refer to
Safety devices on the product on page 101 .
Do an inspection of the collection system (for collection models only).
To clean the product
CAUTION:
washer or a steam cleaner. Water can go
into bearings and electrical connections and
cause corrosion which causes damage to
the product.
Clean the product immediately after use.
•
Do not clean hot surfaces such as the engine,
muffler and exhaust system. Wait until the surfaces
are cool, then remove the grass or dirt.
•
Before you clean with water, clean with a brush.
Remove grass cuttings and dirt on and around the
transmission, the transmission air intake, and the
engine.
•
Use running water from a hose to clean the product.
Do not use high pressure.
•
Do not point the water at electrical components or
bearings. Detergent usually increases the damage.
•
To clean the cutting deck, put it in the servicing
position and clean it with a water hose.
880 - 009 - 31.10.2022
Do not use a high-pressure
First
servicing
To do
To do
To do a
•
When the product is clean, start the cutting deck for
a short period to blow off remaining water.
To clean the engine and the muffler
Keep the engine and muffler free from grass cuttings
and dirt. Grass cuttings soaked in fuel or oil on the
engine can increase the fire risk and the risk that the
engine becomes too hot. Let the engine cool before it is
cleaned. Clean with water and a brush.
Grass cuttings around the muffler dry quickly and are a
fire risk. Use a brush or remove the grass cuttings with
water when the muffler is cold.
Maintenance interval
in hours
50
100
200
O
O
O
O
X
O
O
O
X
X
X
X
X
O
O
X
X
O
O
X
X
X
X
O
O
O
111
Publicidad
Solución de problemas
