To Remove The Lower Belt Covers; To Examine The Steering Wires - Husqvarna R 418TsX AWD Manual De Usuario

2. Remove the 2 screws (A) on the side cover of the
cutting deck.
A
A
3. Loosen but do not remove the screw (B).
4. Turn and remove the side cover of the cutting deck.
5. Install in opposite sequence.
To remove and install the frame tunnel cover
1. Move the seat rearward. Refer to
106 .
2. Remove the 4 screws and remove the frame tunnel
cover.
3. Install in opposite sequence.
To remove and install the right footrest plate
1. Remove the frame tunnel cover. Refer to
and install the frame tunnel cover on page 113 .
2. Turn the knob on the rearward drive pedal (A) to
remove it.
3. Remove the 3 screws (B).
B
4. Loosen the edges of the footrest plate (C).
5. Remove the footrest plate.
6. Install in opposite sequence.
880 - 009 - 31.10.2022
B
To fill fuel on page
To remove
B
A
B
C
To remove and install the left footrest plate
1. Remove the frame tunnel cover. Refer to
and install the front cover of the cutting deck on page
112 .
2. Remove the 3 screws and remove the footrest plate.
3. Install in opposite sequence.
To remove and install the outer right side
cover
1. Open the engine cover. Refer to
install the engine cover on page 112 .
2. Remove the 6 screws and remove the right side
cover.
3. Install in opposite sequence.

To remove the lower belt covers

1. Remove the screws that hold the lower belt cover.
There are 2 screws on the right side of the product
and the 3 screws on the left side.
2. Remove the lower belt cover.
3. Assemble in opposite sequence.

To examine the steering wires

The tension of the steering wires can decrease after
a period of time. This causes the adjustment of the
steering to change.
To remove
To remove and
113