modbar espresso system Manual página 12

WARNING
This appliance is not intended
for use by persons (including
children) with reduced physical,
sensory or mental capabilities,
or with lack of experience and
knowledge, unless they have
been given supervision or
instruction concerning the use
of the appliance by a person
responsible for their safety.
WARNING
- U.S.A. and CANDA only - Do not
connect to a circuit operating
at more than 150V to ground on
each leg.
WARNING
This machine is not suitable for
outdoor use. Jets of water should
not be used to clean the machine,
nor should it be placed where
water jets are used.
12
Note:
• The drinking water mains valve and
the circuit breakers for the electrical
system need to be located in the most
convenient position for the operator to
access them easily and quickly.
1) Power Switch Function
The two-position power switch on the
Modbar module back panel has two
separate functions: ON and OFF.
0 - Off: In this position, the
module is in the off position.
I - Standby Mode: In this position, the module
is in standby mode. When in standby
mode, all operations function as normal,
but no power is applied to the heating
elements. This mode is used for priming
the system upon installation, and can also
be useful for some diagnostic applications.
II - Operating Mode: In this position, the
module is in operating mode. Power is
applied to the heating elements, and all
functions operate as normal.
2) Installation guide
In order to connect the machine up to
the water mains proceed according to the
indications given in the Installation Guide
and in compliance with any local/national
safety standards of the location in which
the machine is being installed.
In order to prevent cracks or leakage: do
not store or install the coffee machine in
places where temperature may cause water
in boiler or hydraulics system to freeze.
Upon installation, the Modbar module
must be primed before use. This is
accomplished by the following steps.
• Ensure that filtered water is supplied to
the module.
• Ensure that the power switch is in the
off position.
• Ensure that the module power cable
is plugged into its appropriate power
source.
• Turn the power switch counter-clockwise
to place it in standby mode.
• Actuate the tap handle in manual
mode, as described in the "Dispensing
Operations" section of this guide.
• After water begins to pour from the tap
(This may take some time on a new