Klarstein RHONE 25 DUO Manual De Instrucciones página 54

EN
54
piston is blocked during closing, it will no longer be able to reach its initial po-
sition. In the initial position, the push piston is flush with the front of cabinet.
In order to set the push piston back in its initial position, disconnect the ap-
pliance from the mains, wait for approx. 10 seconds and plug it back in again.
The push piston will return to its initial position.
The system is not triggered immediately after the door is closed. Allow 3 seconds
and try again. This is not a system failure. The door on the unit is sensitive to pres-
sure. The pressure sensitivity to open the door is possible to adjust as following
steps:
1. Open the door.
2. Rotate the screw on the top middle of door counterclockwise to increase the
sensitivity and clockwise to decrease the sensitivity.
3. Close the door and check if it is correctly adjusted. Rotating the screw coun-
terclockwise too much can cause the door to open automatically even without
pushing or just closing the door hard. In reverse rotating the screw clockwise
too much can cause the door not to open even with heavy pushing.
Interior light
The interior lighting makes it easy to view your wine labels and enhances the
display of your collection.
Touching and holding the LIGHT key for 5 seconds toggles between 2 modes of
operation for the interior lights: functional (default) mode and showcase mode. If
you are in functional (default) mode, the lights will turn on only when the door is
open. The interior light will go out approx. 5 seconds after the door is closed. If
you are in showcase mode, the lights will be on whether or not the door is open
and the light indicator will light up for models with LED display.
The unit is equipped with the LED type lights and they are designed for extremely
long life. Thanks to the LED lighting, the wine will not be adversely affected by
heat or UV light. But they are not user serviceable. To change them pls contact the
service department.
NOTE: Please use only the original LED light fittings provided by the manufacturer.