Publicidad
Idiomas disponibles
Idiomas disponibles
Ambient
temperature
control
This change is automatically cancelled at the next program
change or transition to the next day.
Ambient
temperature
control
14.14 Open window detection
The open window detection is sensitive to temperature
fluctuations. The control unit responds to open windows
according to various parameters: temperature setting, increase
and decrease of ambient temperature, outdoor temperature,
position of the control unit, etc. If the control unit is close to an
entrance door, the detection air can be disturbed by opening
the door. If this is a problem, we recommend disabling window
detection (see installer settings).
When, by opening a window, the control performs a temperature
reduction cycle, a frost protection counter is displayed to show
the cycle duration. The counter is automatically reset the next
time frost protection is activated. By pressing a button, the frost
protection mode is disabled.
Note: if a temperature increase is detected, the control
automatically returns to the previous mode.
14.15 User settings
Access
From Auto, Comfort, Eco or Frost Protection modes:
Long press for 5
Information screens
seconds
Information screens
1
Code 1910000000358 - nv02
Superficial
temperature
control
Superficial
temperature
control
2 short presses
1
= user
settings
Short press
Diagram of setting sequence:
Eco temperature reduction → Frost protection → Upper and
lower Comfort temperature limits → Ambient temperature
limitation → Surface temperature limitation → Maximum Boost
temperature → Reset to factory settings
14.16 Eco temperature reduction
Heating with ambient temperature setpoint:
The reduction is preset to -3.5°C based on the Comfort
reference temperature. It is possible to change it from -1°C to -
8°C, with 0.5°C intervals.
Important: regardless of the set reduction level, the Eco
reference temperature never exceeds 19°C.
Heating with surface temperature setpoint:
The reduction is preset to -30°C based on the Comfort reference
temperature. It is possible to change it from -5°C to - 60°C, with
5°C intervals.
Important: regardless of the set reduction level, the Eco
reference temperature never exceeds 45°C.
Press
or
to display the desired value
Ambient
temperature
control
To confirm and move to the next setting, press
confirm and close settings, press 2x
14.17 Frost Protection
Heating with ambient temperature setpoint:
The device is preset to 7°C. The Frost Protection value can be
changed from 5°C to 15°C, with 0.5°C intervals.
Heating with surface temperature setpoint:
is preset to 10°, the frost protection setpoint cannot be changed:
Press
or
to display the desired value
To confirm and move to the next setting, press
and close the settings, press 2x
- 31 -
English
Superficial
temperature
control
or
. To
. To confirm
.
Publicidad
