Stihl HTA 135 Manual De Instrucciones página 32

English
A cutting attachment consists of the chain, guide bar and
chain sprocket.
1
a
t = a 2
– The pitch (t) of the chain (1), must match the pitch of the
chain sprocket.
– The drive link gauge (2) of the chain must match the
groove width of the guide bar (3).
14.4 Mounting the Harness Clip
► Switch off the pole pruner, @ 16.2.
► Remove the battery, @ 15.2.
2
► Press the harness clip (1) together and place it on the
front handle (2).
14.5 Mounting the Machine Support
► Switch off the pole pruner, @ 16.2.
► Remove the battery, @ 15.2.
30
2
1
3
► Position the left half of the machine support (1) against the
side of the motor housing.
► Insert screw (2).
► Position the right half of the machine support (3) against
the side of the motor housing.
► Insert screw (5).
► Insert and tighten screws (4).
► Tighten screws (2) and (5).
14.6 Mounting and Removing the Guide Bar and
14.6.1 Mounting the Guide Bar and Chain
1
Make sure the battery is removed before starting assembly.
Never operate your pole pruner without a properly mounted
guide bar and chain, @ 6.5. Use only guide bar and chain
combinations expressly recommended or approved by
STIHL, @ 6.4.
The chain has many sharp cutters. If they contact your flesh,
they will cut you, even if the chain is not moving, @ 6.4.
Always wear heavy-duty work gloves when mounting or
otherwise handling the chain, @ 6.3.
14 Assembling the Pole Pruner
2
Chain
WARNING
WARNING
5
3
4
0458-698-8621-A