KRESS KUD12 Manual De Instrucciones página 10

OPERATION
INSTRUCTIONS
NOTE: Before using the tool, read the instruc-
tion book carefully.
INTENDED USE
The power tool is intended for sawing and remodeling
wooden materials, plastic, plaster, non-ferrous metals
and fasteners (e.g. nails and clamps) as well as for
working on soft wall tiles and for dry grinding of small
surfaces. It is especially suitable for working close to
edges and for flush cutting.
ASSEMBLY AND OPERATION
ACTION
Mounting Accessories
Mounting The Sanding Sheet
Operating The On/Off Switch
Using The Variable Speed Dial
Removing or installing battery pack
10 LED light
EN
The variable speed dial can be used to set the optimum
oscillating frequency according to the accessories used
and the respective application.
Oscillation
frequency
High oscillation
frequency:
Low oscillation
frequency:
WORKING HINTS FOR
YOUR TOOL
If your power tool becomes too hot, especially when
used at low speed, set the speed to maximum and
run it with no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds. Always
keep the blade sharp.
Always ensure the workpiece is firmly held or clamped
to prevent movement.
Any movement of the material may affect the quality
of the cutting or sanding finish.
Start your tool before working and turn it off only after
you stop working.
Do not start sanding without having the sandpaper
fitted.
Do not allow the sandpaper to wear away , it will
damage the sanding pad. The guarantee does not
FIGURE
See Fig. A-C
See Fig. D
See Fig. E
See Fig. F
See Fig. G
See Fig. H
Application
Sanding, sawing, rasping and
polishing stone and metal.
Scraping, polishing varnishes.
cover sanding pad wear and tear.
Use coarse grit paper to sand rough surfaces,
medium grit for smooth surfaces and fine grit for
finishing surfaces. If necessary, first make a test run
on scrap material.
Excessive force will reduce the working efficiency
and cause motor overload. Replacing the accessory
regularly will maintain optimum working efficiency.
MAINTENANCE
Remove the battery pack from the tool before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust.
FOR BATTERY TOOLS
The ambient temperature range for tool and battery
use and storage is 0 C-45
o
The recommended ambient temperature range for the
charging system during charging is 0
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities
or retailer for recycling advice.
C.
o
C-40 C.
o o