Trouble Shooting
ERROR
Display does not power on
Partial display LED
Runs with shocks
E-01
E-02
E-04
E-07
E-08
E-13
Belt does not run properly
Belt is slipping
ProRUN.indd 49
POSSIBLE CAUSE
Power plug not connected to the mains
Power switch not in 'ON' position
Socket has no power
Treadmill fuse blown
Faulty MCB
Connections base to upper console
Faulty display
Faulty LED Strip
Faulty LED driver IC
Running belt tension
Running belt alignment
Insufficient driver torque
Communication Error
Stall: impact protection or motor blocked
Incline motor connection error
Incline motor blocked
Incline motor error
Voltage error
Motor or Invertor Error
Broken IC
Abnormal loading
Motor wearing out
Mechanical part blocking
Lubrication
Running belt tension too high
Too much lubrication
Running belt tension too loose
Motor belt too loose
CORRECTION
Plug in power cable
Turn power switch to 'On' position
Check AC (mains)
Replace fuse
Check and or replace MCB
Replug all connections
Replace display
Replug all console connections
Replace Display
Adjust running belt tension
Adjust running belt aligment
Adjust torque potentiometer
Check wiring invertor > Console
Replug connectors console
Replug connectors invertor
Replace invertor
Turn motor manually for few rotations,
and check again
Replug all incline motor connections
Restart treadmill
Replace incline motor
Check Grid Current
Install current regulator
Check commercial current
Replace MCB
Replace motor
Check all moving parts (rollers,
bearings, belt...)
Apply lubrication (silicon spray)
Adjust belt tension
Try to remove overspill using dry towel
Adjust belt tension
Adjust motor belt tension
3/3/2021 2:51:23 PM