red lion RLHE-300 Manual Del Propietário página 2

SAFETY INSTRUCTIONS
Specifications
SAFETY INSTRUCTIONS
This equipment should be installed and serviced by technically qualified personnel who are familiar with
the correct selection and use of appropriate tools, equipment, and procedures. Failure to comply with
national and local electrical and plumbing codes and within Red Lion recommendations may result in elec-
trical shock or fire hazard, unsatisfactory performance, or equipment failure.
Know the product's application, limitations, and potential hazards. Read and follow instructions carefully to
avoid injury and property damage. Do not disassemble or repair unit unless described in this manual.
Refer to product data plate(s) for additional operating instructions and specifications.
Failure to follow installation or operation procedures and all applicable codes may result in the following
hazards:
Risk of death, personal injury, or property damage due to explosion, fire,
or electric shock.
• Do not use to pump flammable, combustible, or explosive fluids such as gasoline, fuel oil, kerosene,
etc.
• Do not use in explosive atmospheres or hazardous locations as classified by the NEC, ANSI/NFPA70.
• Do not handle a pump or pump motor with wet hands or when standing on a wet or damp surface, or
in water.
• When a pump is in its application, do not touch the motor, pipes, or water until the unit is unplugged
or electrically disconnected.
• If the power disconnect is out of sight, lock it in the open position and tag it to prevent unexpected
application of power.
• If the disconnect panel is not accessible, contact the electric company to stop service.
Risk of severe injury or death by electrical shock.
• To reduce risk of electrical shock, disconnect power before working on or around the system. More
than one disconnect switch may be required to de-energize the equipment before servicing.
• Wire pump system for correct voltage.
• Be certain that this pump is connected to a circuit equipped with a ground fault circuit interrupter
(GFCI) device if required by code.
• The pump includes a grounding connector. To reduce risk of electric shock, be certain that it is prop-
erly connected to ground.
• To avoid hazards when installing or servicing, install a double-pole disconnect near the pump instal-
lation.
• Use an appropriate discharge resistor to discharge the capacitor prior to working on the motor.
• This pump has not been investigated for use in swimming pool or marine areas.
• Check local electrical and building codes before installation. The installation must be in accordance
with their regulations as well as the most recent National Electrical Code (NEC) and the Occupational
Safety and Health Association (OSHA), or Canadian Electrical Code (CEC).
• Employ a licensed electrician.
2